Hypax Pte Ltd
BLK 809, FRENCH ROAD #01-156/01-178 KITCHENER COMPLEX, SINGAPORE 200809.
TEL: 65-2917222, 65-2920426   FAX: 65-2940372


Oil Seal
 
STANDARD TYPES

                        Note: 1) Metal encased seals are most suitable for steel or cast iron housing materials, with low coefficient of thermal
                                       expansion and fine finishers.
                                   2) Rubber covered O.D seals are most suitable for soft alloy or plastic housing materials and also suitable for
                                       steel or cast iron housing materials, with high coefficient of thermal expansion and rough bore finishes.
                                       Material are available in Buna-N (NBR) and Viton® (Fluorocarbon).

*** Please contact us if your required type is not listed here ***

000.jpg (8903 bytes) B C

Metal casing with fluid side rubber covered.

Rubber casing with an inner metal component. Design for excellent O.D. sealing ability.
 
S

SINGLE LIP
General oil sealing applications and severe grease sealing application. Spring fitted seal lip. Most popular seal type.
 
SB-Type  SB SC-Type  SC
T

DOUBLE LIP
With dust lip added. Capable are the same as S-Type. Dust lip can exclude light foreign materials. Spring fitted seal lip.
 
TB-Type  TB TC-Type  TC
V

SINGLE LIP
Economical design for grease & dust sealing. Not suitable for viscous fluid. Springless design. Can be used with S-Type, or T-Type seal.
 
VB-Type  VB VC-Type  VC


| INTRODUCTION || PRODUCTS || CONTACT US |


Home      Home


Viton® is registered trademarks of DuPont Dow Elastomers.

Information in this document is subject to change without notice.
No material may be reproduced electronically or print without permission from Hypax Pte Ltd.
Copyright © July 1996 Hypax Pte Ltd. All Rights Reserved.